Gtco Super L III - Users Guide Bedienungsanleitung PDF herunterladen (Seite 48)

Super L III 48

Programming Example: To Send Version Command and Display Results

This QBASIC program interacts with Super L III in Command Mode. In this example, the

program activates Command Mode, sends the VR command and displays the resulting

firmware version transmitted by the Super L III.

1. Configure Super L III for 9600, N, 8, 1, GTCO ASCII and Point (SuperSet 42).

2. Enter and run this QBASIC program:

CalComp Emulation Commands

Super L III recognizes a subset of the CalComp 3400 command set. Space does not permit

a detailed description of CalComp commands. However, most of the commands in this

subset have equivalent Super L III commands. For further information about the operation

of those commands, please refer to the Super L III command or function description in the

GTCO CalComp by Turning Technologies Super L III Command Summary.

NOTE: CalComp commands must be terminated with a <CR>, which is not shown in the

codes listed here. Commands can be strung together by substituting an @ character for

the <ESC>% sequence after the first command and postponing the <CR> until the end of

the multiple command string.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 75 76

Keine Kommentare

Gtco Super L III - Users Guide Bedienungsanleitung Seite 48