Gtco Small Format Station Command Bedienungsanleitung PDF herunterladen

Products and Models covered by this document:

Creation Station 4 x 5 RS-232

Creation Station Pro 6 x 9 RS-232

Creation Station Pro 12 x 12 RS-232

Creation Station Pro 12 x 18 RS-232

Design Station 4 x 5 RS-232

Design Station Pro 12 x 12 RS-232

Design Station Pro 12 x 18 RS-232

11050

11090

11120

11180

35050

35120

35180

RS-232 unit powers up as:

19200 8 n 1

Format 20 with extended data enabled.

Increment run mode.

Out of proximity data enabled.

NOTE: All information contained in this document is proprietary. No copies can be

made without the consent of GTCO CalComp by Turning Technologies.

1 2 3 4 5

Seite 1

Products and Models covered by this document: Creation Station 4 x 5 RS-232 Creation Station Pro 6 x 9 RS-232 Creation Station Pro 12 x 12 RS-232

Operating Modes Run Mode: Digitizer outputs coordinate data continuously. Increment Mode Filter: Puts a movement filter on data in any mode. Th

Dtr cts wiggle CTS should be high well before DTR is dropped (1/18). DTR low times should be at least one timer tick (1/18) long and no longer t

23 Format Cursor Coding Commands DC1 (X ON) start transmission after a x off (SAME AS “ESC % A 1”). DC3 (X OFF) stop transmission on the next pa

Seite 5

9X00 Commands NOTE: Commands should not be sent back to back. There should be an estimated .002 sec delay between commands (2 char at 9600). Al

Keine Kommentare

Gtco Small Format Station Command Bedienungsanleitung