Gtco CR 1212 - Configuration Bedienungsanleitung PDF herunterladen (Seite 5)

Changing Jumpers

Change the jumper caps as you wish.

Configuration

Jumper W5

Jumper W7

Jumper W8

Jumper W9

100 reports per second

cap removed

72 reports per second

cap attached

cap removed

Bit PD One

cap removed

cap attached

Bit Pad Two

cap attached

Baud rate 9600

cap removed

AutoBaud

cap attached

The jumper caps are small black plastic sleeves, open at two ends. Spare caps are

provided. They are stuck on one of the jumpers’ pins.

To remove a cap, pull straight up. To attach a cap, push straight down onto the two jumper

pins. Both ends of the cap are the same, so it does not matter which way you attach it.

Hint: A cap is “attached” when it straddles both pins. It is “removed” when it is on no pins

or on only one pin. Therefore, a handy way of storing a spare cap is to stick it on only one

jumper pin.

1 2 3 4 5 6 7 8

Keine Kommentare

Gtco CR 1212 - Configuration Bedienungsanleitung Seite 5