Gtco UltraSlate Commands Bedienungsanleitung PDF herunterladen

Power Up Default

9600 8 no parity 1 stop bit

Format #23

Run mode

1000 lpi

100 pps

Operating Modes

Run Mode: Digitizer outputs coordinate data continuously.

Increment Mode Filter: Puts a movement filter on data in any mode. The transducer must

move N counts before the data can be sent. Then both axis data are updated. If out of

proximity data is enabled in increment mode, one data point may be sent on leaving

proximity.

Prompt Mode Modifier: Places the additional restriction on data transmission that the host

must transmit a prompt character to the tablet for each data point output. All other rules

of normal operation apply. The prompt character is “?”. Prompting is a feature, which

operates in conjunction with any of the above standard modes.

Send Data Out of Proximity Mode Modifier: If this flag is set, coordinate data will be sent

when it meets the output conditions in or out of the active area. Cordless units may not

respond to button information until cursor is close to tablet.

NOTE: This command should be sent after the mode commands.

Send Data in Margin: If this flag is set, coordinate data point will be sent when it meets the

output conditions in the active area or when in margins.

NOTE: Margins on some of the tablets are very small and are larger leaving the tablet than

coming in.

1 2 3 4 5

Seite 1

Power Up Default 9600 8 no parity 1 stop bit Format #23 Run mode 1000 lpi 100 pps Operating Modes Run Mode: Digitizer outputs coordinate data con

Seite 2

Plug and Play (WINDOWS 95) *.2+/- .035 SEC DTR goes high and then within 165 msec to 235 msec CTS goes high. Then the tablet sends the “plug and

Binary Formats 20 Format AFT 23 Format

Pen Coding Commands (RS-232) DC1 (X ON) start transmission after a x off (SAME AS ESC % A 1). DC3 (X OFF) stop transmission on the next packet (SA

Seite 5

Keine Kommentare

Gtco UltraSlate Commands Bedienungsanleitung